Build 2.0.0 (3/04/2025) - download
Release Notes
New Features:
- Analog input module support only for Pm50 Analog device.
- Push notification is enabled.
- New RLC command to support the analog module.
- New Modbus commands to support analog module.
- Setpoint can be configured for input 1 or 2.
- Analog output can be configured for input 1 or input 2.
- UI update for analog module config:
- Users can edit the label for each list. The active list label will be displayed on the home screens, such as the gauge or numeric screen. If not edited, the default label will be shown.
- The function key list selection option can select an independent list for each input. For user key it will toggle the list.
- Large Numeric screen is default screen no 3 & 4 in 4.3” device.
- The last active screen is shown after power up (if screen 3 & 4 was active, then after power up screen 3 & 4 will be shown instead of default 1 & 2 screen).
Build 1.4.6 (8/05/2024) - download
Release Notes
New Features:
- Password Recovery
- 7 Digit - 9 Digit Screen
Build 1.4.3 (7/13/2023) - download
Release Notes
New Features:
- Push notifications
- Updated supervisor mode functionality
Bug Fixes:
- In Digital, Setpoint was triggered twice in Latch and Timeout action
- GPM- With a new self-signed certificate device is rebooting
- Quad relay module with Time ON and Time OFF fails while switching
Known issue due to migration to new SDK:
- 1200 baud rate not working as expected over RS232
- In Analog, Setpoint status post power cycle issue
- In Digital 4.3”, In Counter C serial Slave Literal Characters font size need to be modified for Numeric and Large numeric
- In Digital Web/App, in the Output Timed Outfield for value 1.10 is saved as 655.35
- Timeout error in Modbus ASCII/RTU Over RS232 with the default configuration
- First time when user “Print” using function key/user input for RLC over 232
Build 1.4.1 (5/8/2023) - download
Release Notes
Enhancements:
- Pushing Messaging capability
- Quick Access capability
Bug Fixes:
- Certificate pop-up issue
Build 1.4.0 (6/24/2022) - download
Release Notes
Bug Fixes:
- SDK updated to support both new & old flash in the MCU
- Fixed issue in web app for counter & rate decimal point not showing in gauge screen
- 200µA enabled in factory test
- Updated Logout Functions
Known issue due to migration to new SDK:
- Rate max capture’s spike, observed in Rate A, Rate B & Rate C. Issue will be resolved in Build 1.4.1
Note: Contact Tech Support for downloads of firmware versions 1.3.0 or earlier.
Build 1.3.0 (2/8/2022)
Release Notes
Bug Fixes:
- Updated Probe Burnout
- Corrected Annunciator Flashing
- Corrected Reset Functions
- Updated Logout Functions
Build 1.2.6 (12/30/2021)
Release Notes
- Initial Digital Firmware Release
Build 1.2.2 (12/14/2021)
Release Notes
- Initial Analog Firmware Release